^ When removing the filters for
cleaning, also clean off any residues
of oil or fat from the now accessible
housing to prevent the risk of fire.
When replacing the grease filters,
ensure that the locking clips are facing
down towards the hob.
If a filter has been replaced upside
down:
^ Insert a small screwdriver into the slot
as shown to disengage it. Do not let it
drop onto the hob below.
^ After replacing the grease filters,
press the grease filter touch control
for approx. 3 seconds to re-set the
operating hours counter.
The indicator light will go out.
^ If the grease filters are cleaned
before the operating hours counter
has reached its maximum, the grease
filter touch control should be pressed
for approx. 6 seconds to reset the
counter.
Downloaded from
www.Manualslib.com
manuals search engine
Cleaning and care
Fitting and replacing the
charcoal filter
If the cooker hood is connected for
recirculation, a charcoal filter (one on
the DA 119 or two on the DA 112) must
be inserted in addition to the grease
filters. Charcoal filters absorb normal
kitchen odours.
They are fitted in the canopy above the
grease filter.
Charcoal filters can be obtained from
your dealer or the Miele Spare Parts
Department.
See back cover for contact details, and
"Technical Data" for model number.
^ Before fitting or replacing the
charcoal filters, the grease filters
must first be taken out (see previous
section for instructions on how to do
this).
^ Two brackets (DA 119) or four
brackets (DA 112) have to be fitted
for securing the charcoal filter. See
the Installation Sheet supplied with
the cooker hood for instructions on
how to fit them.
^ Take the charcoal filter out of its
packaging.
There are two filters in every pack.
Only one of these is required for the
DA 119. When you have removed
one charcoal filter from the pack,
take care to re-seal the package
again properly. Otherwise the
remaining charcoal filter will
deteriorate and be less effective
when you need to start using it.
49