Charging The Battery; Bluetooth Operation - Trevi XF 600 KB Gebrauchshinweise

CHARGING THE BATTERY

1. With the appliance off, connect the power supply cable to the socket (6) on the device.
Connect the power supply to a mains socket;
2. The Led indicator (7) will light up in Red;
3. When charging is complete, the LED indicator (7) will turn green;
4. With the battery low, the last segment of the battery icon on the display will flash for
a certain time, then the device will automatically go into standby mode.
Note:
- For a good battery life, it is recommended to keep the device off during the charging phase.
Unless otherwise specified, the commands described below apply to both the unit and
the remote control.
ON/ OFF
- Use the On/ Off switch (8) to turn the appliance on and off.
- Press the STANDBY button (9) on the remote control to put the unit in standby mode;
press it again to turn the unit back on.
VOLUME / TONE / MIC VOLUME / ECHO EFFECT
1. Turn the Volume knob (15) clockwise / counterclockwise to increase / decrease the
volume of the appliance;
2. Press the MENU 'button (10) and turn the knob (15) to activate the adjustment of the
high, low tones, microphone volume and echo effect;
3. The same settings are also present on the remote control; through the EQ button (7)
it is also possible to change the audio dynamics by choosing from the preset ones:
POP , ROCK, JAZZ, CLASSIC, FLAT.

BLUETOOTH OPERATION

PAIRING TO DEVICES
1. Position the speaker near the Bluetooth device to be paired and turn on the device;
2. Press the MODE button (13) several times until the flashing word "BLUE" appears on
the display;
3. Follow the instructions of your external device to search for the speaker;
4. Search for the speaker named "XF 600 KB" and enter the PIN "0000" if required;
5. Once paired, the word "BLUE" on the display will remain fixed.
Note:
- The Bluetooth speaker only works with one connection at a time, the connection
cannot be interrupted during normal operation.
- The proximity of TV sets, neon lamps or other appliances can cause disturbances in
reception, in this case move the appliance away.
CONTROLS AVAILABLE IN BLUETOOTH MODE
- Start sound reproduction from your device.
- Press the button 9 (14) once to go to the previous track, press the button once :(11)
10