cecotec TOTALPURE 2500 CONNECTED Bedienungsanleitung Seite 37

The device does not turn
on.
The device's performance
is lower than usual
If your problem persists, please contact Cecotec's customer service.
05620_05621_05622_TotalPure 2500_5000_7500_ Connected_Manual_YV_01200320.indd 37 05620_05621_05622_TotalPure 2500_5000_7500_ Connected_Manual_YV_01200320.indd 37
The device is not turned on.
The dynamo is damaged.
The device is placed on an
unstable surface.
Loose or foreign particles
inside the device.
The motor is loose.
The plastic packaging of each
filter has not been removed.
The washable mesh filter is
dirty.
The filter has not been
replaced.
The device's air inlet or outlet
is blocked.
The plastic packaging of each
filter has not been removed.
The gap between the device
and other objects is not the
adequate one.
The device's filter is missing.
The device exceeds the
adequate covering area.
TOTALPURE 2500 / 5000 / 7500 CONNECTED
ENGLISH
Plug the device in and switch
it on again.
Contact Cecotec's customer
service.
Place the device on a stable
surface.
Contact Cecotec's customer
service.
Contact Cecotec's customer
service.
Before using the device,
remove the plastic pack
Clean the device's mesh filter.
Replace a set of new filters.
Contact Cecotec's customer
service.
Before using the device,
remove the plastic packaging
of each filter.
Make sure the distance
between the device and
other objects is 50 cm from
both sides of the air inlet and
outlet, and 10 cm from the
back of the device.
Make sure all the filters are
installed correctly.
Make sure the device
operates on an adequate
covering area.
37
20/3/20 15:18 20/3/20 15:18