Operation; Receiving Satellite Tv Signals; Turning The System On/Off; Changing Channels - Megasat Campingman WSTA-DP250P Bedienungsanleitung

O
peration peration
peration peration
DP250P
antenna system is easy to use. Under normal conditions, operation of DP250P
antenna requires no intervention from the user. Antenna unit initialization and satellite
acquisition is completely automatic.

Receiving Satellite TV Signals

Receiving Satellite TV Signals Receiving Satellite TV Signals Receiving Satellite TV Signals
Television satellites are located in fixed positions above the Earth's equator and beam TV
signals down to certain regions of the planet. To receive TV signals from a satellite, you must
be located within that satellite's unique coverage area. To check it, see "Appendix B –
Satellite Coverage Map" In addition, since TV satellites are located above the equator,
DP250P antenna must have a clear view of the sky to receive satellite TV signals. Anything
that stands between the antenna and the satellite can block the signal, resulting in lost
reception. Common causes of blockage include lighthouses, boat masts, trees, buildings, and
bridges. Heavy rain, ice, or snow might also temporarily interrupt satellite signals.

Turning the System On/Off

Turning t Turning t Turning t he System On/Off he System On/Off he System On/Off
Since power to DP250P system is controlled by the IDU, you can turn the antenna on or off
by applying/removing operating power to the IDU.
Turning on the System
Follow the steps below to turn on your DP250P System.
1. Make sure the antenna has a clear view of the sky.
2. Turn on your satellite TV receiver and TV.
3. Apply operating power to the IDU.
4. Wait one minute for system startup. The IDU will display the Tracking
Satellite screen after system testing is complete.
Turning off the System
Follow the steps below to turn off your DP250P System.
1. Remove operating power from the IDU.
2. Turn off your satellite TV receiver and TV.

Changing Channels

Changing Channels
Changing Channels Changing Channels
If you have followed the installation instructions, your system should be set to the satellite of
your choice and the system should have downloaded the appropriate channel guides. When
DP250P antenna system and satellite receiver is properly configured, it is easy to change the
channel using the remote control that normally comes with the receiver unit.