Krups XP52 AUTOMATIC Gebrauchsanweisung Seite 74

KR_XP52-AUTOMATIC_EO_NC00026254-01 29/11/11 15:36 Page70
English
Problems
The water tank leaks
when it is carried.
Water leaks under
the appliance.
Water leaks under
the appliance.
Water leaks under
the drip tray
Crackles are heard
in the filter holder.
The pump is
unusually noisy or
the 4 lights flash.
The cups are not
filled equally.
Lots of water on the
ground coffee, in the
filter holder.
The machine leaks
on the sides of the
filter holder.
Your espresso tastes
bad.
The espresso has no
froth (crema on
coffee).
70
Possible causes
The valve at the bottom of
the tank is dirty or defective.
The valve is blocked by
scale.
Internal leak.
Internal leak.
Water can be present
and/or flow when you
remove the drip tray.This is
not a sign of a leak.
Normal phenomenon:
the filter holder security lock.
No water in the tank.
Tank poorly fitted.
The Claris cartridge is not
filled with water.
The filter holder is clogged.
Coffee insufficiently tamped
down.
Insufficient amount of coffee.
The filter holder has not
been properly positioned.
The edge of the filter holder
is clogged by ground coffee.
Pod poorly positioned in the
filter.
The percolation head seal is
dirty.
The percolation head seal is
defective.
After descaling, the rinsing
was not performed properly.
Coffee grounds too coarse,
stale or too dirty.
Solutions
Wash the water tank and operate the valve at the
bottom of the tank with your finger.
Descale the appliance (paragraph 9).
Check the position of the tank. If the fault persists,
do not use the appliance, contact an approved
service centre.
Check the position of the tank. If the fault persists,
do not use the appliance, contact an approved
service centre.
Stop the appliance, fill the water tank and turn the
machine back on.
Press down firmly on the tank.
Please refer to paragraph 5.
See paragraph 8.
Tighten the filter holder as far as it will go, up to
the stop (fig.7).
Add more espresso ground coffee.
Put the filter holder in place and lock it (by turning
it to the right as far as it will go, up to the stop).
Remove excess coffee.
Place all the paper inside the filter holder.
Clean the seal with a damp cloth.
Contact a Krups approved service centre.
Rinse the device according to the manual (see
paragraph 9).
Try fresher or finer espresso coffee grounds.