KULZER signum HiLite pre 2 Gebrauchsanweisung Seite 12

6 Setting up, installation and putting into operation
When transporting the unit, do so carefully in a horizontal position. Avoid jerking it!
For dimensions and weight, see section 10 'Technical details'.
After unpacking, check that the delivery is complete, i.e. the unit and all accessories are present, and dispose of the
packaging material in accordance with local environmental regulations.
CAUTION
Safety regulations for setting up, installing, placing into operation and operating the unit.
Following the instructions below is imperative:
– Before putting into operation check to make sure that the figures on the rating plate agree with the local
power supply figures.
– The power supply unit must be fitted with the appropriate country-specific mains connection adapter.
– Check the mains connection cable and plug for damage before use. If there is damage, the do not plug the
unit into the mains.
– Do not short the electrical contacts on the handpiece by bringing them into contact with metal objects or
liquids.
– The unit must be installed in an impact-resistant location protected from water and liquid splashes.
GB
– Do not set up the unit above or near sources of heat. During installation, sufficient space must be maintained
around the unit.
- 4 -
– Never expose the unit to direct sunlight or ultraviolet radiation.
– Do not set up the unit in potentially explosive areas where highly flammable air/gas mixtures prevail or may
arise (anaesthetic mixtures, isopropanol fumes, etc.). If necessary, take measure to provide room ventilation.
– Place the orange glare shield on the lens barrel (Speed Focus) . Slide the protective covering over the
on/off switch.
– Avoid any direct contact between the HiLite pre 2 and the material to be pre- polymerization or gelled.
– Pre-polymerized composite residues on the light exit surface impair light emission and have a negative
effect on subsequent cycles.
NOTE
Please refer to the separate instructions for use of the particular material for pre­polymerization curing times.
An additional Kulzer polymerization unit is required for final polymerization, e.g. HiLite
cara Print LEDcure.
WARNING
Never point the light into the eyes. Wearing safety glasses that filter out the blue to ultraviolet light range
must be worn to prevent direct or indirect light exposure to the eyes. The unit does not emit any significantly
powerful UV light (<385nm).
7 Appliance
7.1 Battery
The HiLite pre 2 is supplied with power from a rechargeable lithium ion battery.
CAUTION
When inserting the battery, make sure the (+) pole goes first. If inserted incorrectly, the HiLite pre 2 will not
work. Additionally the battery will not charge and if charging is attempted the charge indicator will blinking red.
Safety regulations for the battery:
– Keep the battery out of children's reach.
– Only use genuine
– To charge the battery only use the magnetic charging clip.
Do not charge the battery with universal battery chargers. Risk of explosion and fire!
– Dispose of the battery in a suitable manner in accordance with the laws applicable. Under no circumstan-
ces may it be disposed of along with domestic waste.
The owner is liable for any damage caused by improper disposal of the battery.
– Do not use the battery for purposes other than those specified.
WARNING – RISK OF EXPLOSION
– Do not open, pierce or squash the battery; it contains toxic substances.
– Do not burn the battery or expose it to high temperatures – risk of explosion!
Kulzer GmbH batteries.
power 3D or
®