Jeti SPIN pro Serie Handbuch Seite 21

SPIN SPIN
PRO PRO
position is stored in the memory (END POINT), otherways follow groups of five repeating tones
according to the appropriate mode:
Tx Power ON
Rx Power ON
time
t
5s
First melody
Brake
Acro inrunner
Acro outrunner
Glider inrunner
Glider outrunner
Heli constant RPM
Heli Auto
( )
www.modellmarkt24.ch www.modellmarkt24.ch
single tones - Mode 1 Acro inrunner:
- this mode is appointed to aerobatic models driven by motors of
classic conception. (inrunner)
- brake not active
- timing 0°
- LiXX-3,2V per cell
two tones - Mode 2 Acro outrunner:
- this mode is appointed to aerobatic models driven by motors of
the reversed conception (outrunner).
- brake not active
- timing 24°
1
- LiXX-3,2V per cell
groups of three tones - Mode 3 Glider inrunner:
- this mode is appointed to gliders driven by motors of classic
conception (inrunner).
2
- brake activated
- timing 0°
- LiXX-3,2V per cell
3
groups of four tones - Mode 4 Glider outrunner:
- this mode is appointed to gliders driven by motors of the reversed
conception (outrunner).
- brake activated
4
- timing 24°
- LiXX-3,2V per cell
groups of five tones - Mode 5 Heli constant RPM:
- this mode is appointed to model helicopters with the claim or
5
constant speed regulation with changing load/unload of the rotor.
This mode does not support fast speed changes
- timing 0°
- LiXX-3,2V per cell
6
groups of six tones - Mode 6 Heli Auto:
- the same like mode 5, but RPM range is set automatically
- LiXX-3,2V per cell
Confirmation of the setting is carried out by shifting back the throttle
to low throttle position during the tone signals of the factual mode.
Setting saved
21
EN