Initial Configuration - Palazzetti Ecofire Lackie Idro Serie Installations- Und Wartungsanleitungen

6.4 Initial configuration

Depending on the type of installation, the stove must be set according to the most
correct configuration for its operation.
Before proceeding, the stove must be powered.
a) Use the arrow keys
b) select the password "7" with the key
c) scroll with the keys
d) press the key
e) press the key
f) the configuration currently in use will be displayed;
g) to modify, press the key
keys ;
h) press the key
After changing the configuration, a communication error message may appear for a
few seconds: ignore it and turn off the stove using the switch on the back, wait a few
seconds and then turn it back on.
6.4.1 It is possible to set four different configurations:
Configuration 1
Set this configuration when the stove is controlled by an external thermostat (or
chronothermostat).
This configuration can also be used to switch the stove on and off manually or in a
programmed manner without the use of an external thermostat, but leaving the two
terminals bridged, as set in the factory.
In this configuration the stove switches off when the external thermostat is satisfied,
or it will modulate the power (to keep consumption to a minimum) when the set water
temperature is reached.
The stove will also switch off in the event that the water temperature continues to rise
despite modulation. In this case the stove will only come back on if the temperature
difference between the set value and the actual value is greater than 20°C.
It is therefore advisable, in this configuration, to set the water temperature to a high
value (e.g. 70°C).
Configuration 2
Set this configuration to switch the stove on and off manually or in a programmed
way when the stove is directly connected to the radiators.
The stove will modulate the power according to the ambient temperature read by
the probe on board.
The antifreeze function can also be set in this configuration.
to go to the set-up menu
and select the submenu [30]; " --0" will flash;
and enter the value "54" with the keys
to confirm;
and enter the value of the new configuration with the
to confirm.
004778021 - 10/01/2020 - PN - Italy
and press the key
and confirm with the key
;
;
;
57