Adjusting Top Burner Primary Air (4 Kw); Adjusting Top Burner Primary Air (7 Kw); Adjusting Top Burner Primary Air (10 Kw) - Angelo Po 0N0FAA Bedienshandbuch

Remove the injector (D) and replace it with
4)
the one suitable for the type of gas in use (see
table at back of manual).
Fully screw the injector .
5)
To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Pull off the knob (A).
2)
Undo the screws (C) and remove the control
3)
panel (B).
Undo the screw (D).
4)
Set the burner mount (E) at a distance of 17
5)
mm. and tighten the screw (D)
Replace the control panel (B) and the knob (A)
6)
on completion of the operation.
To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Pull off the knob (A).
2)
Undo the screws (C) and remove the control
3)
panel (B).
Undo the screw (D).
4)
Set the burner mount (E) at a distance of 20
5)
mm. and tighten the screw (D).
Replace the control panel (B) and the knob (A)
6)
on completion of the operation.
To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Pull off the knob (A).
2)
Undo the screws (C) and remove the control
3)
panel (B).
Undo the screw (D).
4)
Set the burner mount (E) at a distance of 20
5)
mm. and tighten the screw (D).
Replace the control panel (B) and the knob (A)
6)
on completion of the operation.
3319960_inst_GB_rev.1

ADJUSTING TOP BURNER PRIMARY AIR (4 KW)

ADJUSTING TOP BURNER PRIMARY AIR (7 KW)

ADJUSTING TOP BURNER PRIMARY AIR (10 KW)

After making the setting, seal the screw with
6)
paint.
Replace the control panel (B) and the knob
7)
(A) on completion of the operation.
A
B
A
B
A
B
- 11 -
C
C
C
C
C
C
D
D
GB
D
ENGLISH