Parts Supplied - Pioneer AVIC-X3 Installationsanleitung

Installation
! If installation angle exceeds 30º from hori-
zontal, the display unit might not give its
optimum performance.
! The cords must not cover up the area
shown in the figure below. This is neces-
sary to allow the amplifiers and navigation
mechanism to dissipate heat.
The display unit
Do not cover this area.
The hide-away unit
Do not cover this area.
! The semiconductor laser will be damaged
if it overheats, so don't install the display
unit anywhere hot — for instance, near a
heater outlet.
! When installing the hide-away unit in the
boot, use the extension cable (e.g. CD-
SC300E)(sold separately).
! Do not install the display unit in a position
where the opening of the LCD panel is ob-
structed by any obstacles, such as the
gearstick. This may cause interference with
the gearstick, or a malfunction of the me-
chanism of the display unit.
! Make sure you leave enough gap between
the dashboard and the LCD panel of the
display unit so the LCD panel can be
opened and closed without contacting with
the dashboard.
Dashboard
Leave gap
LCD panel

Parts supplied

Parts marked (*) are pre-installed.
The hide-away unit
Holder*
Washer faced screw
(4 mm × 8 mm)
(4 pcs.)
Frame*
Section
The display unit
Side bracket
(2 pcs.)
Self-tapping screw
(6 mm × 16 mm)
(4 pcs.)
Side bracket (small)*
(2 pcs.)
21
Engb
04