To Guard Against Electromagnetic Interference; Before Installing; Installing This Navigation System; Installation Notes - Pioneer AVIC-X3 Installationsanleitung

Section
04 Installation
To guard against
electromagnetic interference
In order to prevent interference, set the follow-
ing items as far as possible from this naviga-
tion system, other cables or leads:
! TV aerial and aerial lead
! FM, MW/LW aerial and its lead
! GPS aerial and its lead
In addition you should lay or route each aerial
lead as far as possible from other aerial leads.
Do not bind them together, lay or route them
together, or cross them. Such electromagnetic
noise will increase the potential for errors in
the location display.

Before installing

! Consult with your nearest dealer if installa-
tion requires the drilling of holes or other
modifications of the vehicle.
! Before making a final installation of this
product, temporarily connect the wiring to
confirm that the connections are correct
and the system works properly.
Installing this navigation
system

Installation notes

! Do not install the display unit or the hide-
away unit in places where it may become
subject to high temperatures or humidity,
such as:
— Places close to a heater, vent or air con-
ditioner.
— Places exposed to direct sunlight, such
as on top of the dashboard or the rear
shelf.
— Places that may be splashed by rain, for
example close to the door.
20
Engb
! When installing the unit choose a position
that is strong enough to bear the weight of
the unit. Choose positions where the dis-
play unit or the hide-away unit can be firmly
installed, and install it securely. Unless the
display unit or the hide-away unit are se-
curely attached, the current location of the
vehicle cannot be displayed correctly.
! Do not install the hide-away unit on the
board covering the spare tyre or other
places which are subject to vibration.
! When the hide-away unit is installed under
a front seat, ensure that it does not ob-
struct the sliding action of the seat.
! When installing the hide-away unit, choose
a position that ensures there will be no con-
tact with luggage. The impact of a heavy
weight or sudden shock on the hide-away
unit will adversely affect the accurate dis-
play of the current location of the vehicle.
! Avoid installing the hide-away unit in
places where it will interfere with loading
and unloading of the spare tyre, jack, tools,
etc.
! Check that a disc can be ejected with the
display unit installed.
! Install the hide-away unit horizontally on a
surface within +30 degrees to –30 degrees
tolerance (within five degrees to the left or
right of your vehicle's direction of travel).
Mis-installing the unit with the surface
tilted more than these tolerances would in-
crease the potential for errors in the loca-
tion display, and might otherwise cause
reduced display performance.