Automatic Time Setting; Manual Time Setting; Display Change - Bresser National Geographic VA 9070710 Bedienungsanleitung

8. Wait until the indoor temperature is displayed on the base station.
NOTICE! When switching from mains power supply to battery power supply or vice versa,
the power supply is being disabled for a short moment for technical reasons. Exception: per-
manent battery operation.
Remote sensor
9. Remove the battery compartment cover.
10. Insert the batteries into the battery compartment. Ensure that the battery polarity (+/-) is correct.
11. Set the channel selector switch to the desired channel.
NOTICE! This weather station can be operated with one or more remote sensors. Each re-
mote sensor being connected must be operated on a different channel. If only one remote
sensor is connected, it should be operated on channel 1.
12. Replace the battery compartment cover.

10 Automatic time setting

After the power is restored, the unit automatically searches for the radio signal. It takes approximately
3-8 minutes for this process to complete.
If the radio signal is received correctly, the date and time are set automatically and the reception sym-
bol is displayed.
NOTICE! Some functions/buttons are deactivated during radio signal reception.
If no radio signal is received, proceed as follows:
1. Press the UP button on the base unit for approx. 3 seconds to activate reception of the radio sig-
nal. Reception is now initialized again.
2. If still no radio signal is received, the time must be set manually.

11 Manual time setting

To set the time/date manually, first check whether the radio symbol in the display is still flashing (auto-
matic reception of the time signal is then still active). Now press the UP button for approx. 3 seconds
to deactivate reception.
1. Press the SET button for approx. 3 seconds to enter the time setting mode.
2. Digits to be set are flashing.
3. Press UP or DOWN button to change the value.
4. Press the SET button to confirm and switch to the next setting.
5. Sequence of the settings: Hours > minutes > year > day/month, month/day > month > day > air
pressure unit > exit
6. Finally, press the SET button to save the settings and exit settings mode.

12 Display change

• In normal display mode, press the DOWN button to toggle the time display between 12-hour or 24-
hour mode.
• In normal display mode, press the SET button to switch between time and date.
• In normal display mode, press the UP button to toggle between °C and °F when displaying the
temperature unit.
• In normal display mode, press the CHANNEL button for about 3 seconds to clear the outdoor
sensor data and reinitialize sensor reception.
• In normal display mode, press the MEM button several times to display the set Max/Min values
one after another.
21 / 28