Cleaning And Storage - BOMANN bs 980 cb Bedienungsanleitung

Illustration D
Illustration E
Cleaning the Dust Container and Filter Inserts
Filter Insert, Motor protection fi lter
• Quick clean: Tap or brush the fi lters out in order to remove
any residues. The quick clean is recommended every time
the dust container is emptied.
• Hand wash: In the case of more intense soiling we recom-
mend a hand wash up to 40°C.
CAUTION:
You should always carry out this cleaning process if the
suction power of the device is reduced!
NOTE:
• Simply allow the fi lters to dry in the air!
• The device should only be used again when the fi lters are
dry!
Outlet fi lter (13)
The appliance is also equipped with an outlet fi lter.
• In order to ensure that the fi lter works correctly, we recom-
mend that you replace it every six months.
• This fi lter is to be found on the top side of your device under
a ventilation grille.
• Pull on the button to open the grille.
34
05_BS 980 CB 34
(see illustration D)
• Open the clip on the lid (b)
in order to release it from the
dust container (a).
• Turn the fi lter insert (c) a
small amount in an anticlo-
ckwise direction to release it
from the lid (b).
Motor protection fi lter (d)
• The motor protection fi lter is
located in the dust space.
• The fi lter fi ts vertically into the
rear section of the dust hou-
sing. Pull the fi lter upwards to
remove it (see illustration E).
• Always empty the dust
container fi rst.
• After use you can rinse out
the dust container with clean
water.
• Any soiling in the container
can be removed with a
sponge or nylon brush.
• Remove the grille by pulling upwards.
• Take out the fi lter and clean it as described above.
• Place the fi lter back in position.

Cleaning and storage

Cleaning
• Pull the plug out of the socket before cleaning!
• Clean the casing with a dry cloth.
Storage
• Let the iron cool down completely.
• Wind the cable completely.
• Insert the hook of the nozzle on the back of the device into
the parking aid (8).
Troubleshooting
• The Device Does Not Work.
Remedy:
Check the connection to the mains.
Check the position of the switch.
• The device does not suck up anything.
Possible Cause:
The suction power is set too low.
Remedy:
Check the position of the control switch.
Possible Cause:
The dust bag is full.
Remedy:
Renew the dust bag.
or
Possible Cause:
The dust container or the fi lters are dirty.
Remedy:
Empty or clean the components.
Possible Cause:
There is a foreign body in the suction tube or the nozzle.
Remedy:
Check the accessories for foreign bodies.
NOTE:
Important note!
• Cleaning may become necessary after a shorter time,
depending on the conditions of use, e.g. when vacuuming
fi ne dust.
• If the suction power of your vacuum cleaner diminishes
please clean the fi lters as described.
• If the suction power suddenly diminishes during operation
this may be due to the fi lters being locked.
04.05.2007, 14:35:57 Uhr