GYS AUTOPULSE 220-M3 230 V Bedienungsanleitung Seite 55

Anschlussplan für Push Pull-Brenner
mit Potentiometer (10 KΩ)
1 - Wahl der Einstellung (Geschwindigkeit oder Bogenhöhe)
2 - Orange LED (Bogenhöhe)
3 - Grüne LED (Geschwindigkeit)
4 - Schrittweite (Geschwindigkeit oder Bogen gemäß Taste 2)
5 - Dekrement (Geschwindigkeit oder Bogen gemäß Taste 2)
• Spool Gun torch (4m : Art.-Nr. 041486)
The Spool Gun torch is connected to the connector (I - 12).
This torch can be used only in synergic, standard and manual mode.
- In manual mode, the knob to adjust the wire speed is on the torch (adjustment cannot be done on the machine).
- In synergic mode, the adjusting knob enables to amend the wire speed between 50% to 100% of the interface value.
The detection of the Push-Pull torch is made by a simple press on the trigger.
Procedure of reel assembly on Spool Gun torch :
4
5
1
GERÄTEINSTELLUNG
INFORMATION
Dieses Menü bietet Zugriff auf die Versionsnummern der Schweißparameter und der Software.
AUTOPULSE 220-M3
1- Button opening/closing casing
2- Reel tightening nut
3- Reel break nut (do not tighten too much)
4- Adjsutment screw for rollers tension
5- Adjustment knob for speed wire
- Open the case (1), remove the support nut (2).
- Untighten the reel brake nut (3).
- Insert your reel.
- To insert the wire in the rollers, put a tension on the «adjustment screw for rollers
tension (4)»
- Remove the torch wire by reeling the reel.
3
2
- Plug in the Spool gun command connector and power connector
+ supply (4) +supply (10)
3 2 1
7 6 5 4
10 9 8
logic gnd (5) analog gnd (3)
(53068)
1
2
3
5 4
DE
(1)
+
cursor (2)
M
-
(8)
55