Initial Installation In The Bathtub; Secure Bath Lift To The Bottom Of The Tub - DeVilbiss Healthcare drive BELLAVITA Gebrauchsanweisung

EN

Initial installation in the bathtub

1. First insert the rear suction cups with the movable
plugs in the underside of the base plate (photo 1).
A
A ) Mushroom head | B ) Plug
2. Push the mushroom head of the suction cup through
the small opening by gently rotating it into its fi nal po-
sition. Ensure that the vent tabs face backwards (pho­
to 2).
C
C) Vent tab
3. Push the plug from the upper side into the plate open-
ing until it is fl ush (photo 3).
20
Drive Medical GmbH & Co. KG | As per: 08.06.2020 | Errors and alterations excepted
B
4. Insert the front suction cup in the same way, however
in this case, additionally push the vent tabs into the re-
cesses of the base plate. As a result, the front suction
cups are automatically vented during removal (pho­
to 4).

Secure bath lift to the bottom of the tub

Information which must be observed:
The suction cups secure the bath lift to the bottom of the
tub. The suction cups on the underside of the bath lift
must therefore be clean and dry when the bath lift is used
in the bathtub which is also clean and dry. We recom-
mend regularly cleaning the suction cups and the bath-
tub with commercially available cleansers to ensure the
best possible grip.
1. Ensure that the bottom of the empty bathtub is clean
and that there are no nonslip mats in the tub.
2. Place the seat unit with the suction cups mounted on
the base plate in the empty bathtub such that the rear
suction cups are at the start of the slope at the rear
wall of the bathtub.
3. Then insert the drive unit with integrated backrest, as
shown in photo 5 ­ 6, with its locking catches into the
bearing blocks of the seat unit.
Instructions for use BELLAVITA