Light; Information; Set - Futurelight DMH-80 LED Spot Bedienungsanleitung

With the function "Wireless" you can log in the the wireless receiver in to a wireless transmitter, the fixture
could now receive the wireless DMX signal.
• Select "Wireless" by pressing Up or Down.
• Press the Enter-button to confirm.
If a device with wireless receiver is connected with a DMX-controller via cable, the device will be controlled
by the cabled controller and not by the wireless transmitter.

Light

Max Temperature
With this function you can set the inside temperature at which the projector will automatically switch the LED
off. Press Up or Down to select the maximum inside temperature between 80 °C and 139 °C. Inside
temperatures below 90 °C are not critical. 90 °C and more should lead to the LED being switched off. Please
note that the outside temperature should not exceed 45 °C.

Information

Time information
Current
With this function, you can display the temporary running time of the device from the last power on. The
display shows "XXXX", "X" stands for the number of hours. The counter is reset after turning the device off.
Fixture Life
With this function, you can display the running time of the device. The display shows "XXXX", "X" stands for
the number of hours.
Temperature
Near lamp Temp
With this function you can display the temperature in the projector-head (near CMY-filter) in degree
Celsius/degree Fahrenheit.
...
Fan speed
With this function you can display the current fan speed. The display shows "XXXX", "X" stands for RPM.
DMX indicator
With this function, you can display with which value the respective channel is sent.
Error channels
With this function, you can display the channel errors.
Fixture Model
With this function, you can display the model number and brand of the fixture.
Software version
With this function you can display the software version of each IC.
• Select "Software ver." by pressing Up or Down.
• Press the Enter-button, the display shows e.g. "1U01 VX.X.XX", "X.X.XX" stands for the version number.

Set

Reset
With this function you can reset the device via the Control Board. You can select the different Reset-
functions by pressing Up or Down.
Movement
PAN Reverse
With this function you can reverse the PAN-movement.
TILT Reverse
With this function you can reverse the TILT-movement.
53/60 00111396, Version 1.0