Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4
Use the sliding control FADE to adjust the
fade time, i.e. the time between the steps,
between 0 and 30 seconds The display
shortly inserts the setting, i.e. "FT:11:5S".
Overwriting Channels Manually
During the playback of a chase, it is possible to
overwrite the programmed DMX values with the
sliding controls. This allows for minor adjustments
during a live performance without the need for
reprogramming scenes.
1
Use the buttons SCANNER 1-12 to select
the units to be controlled manually.
2
Adjust the desired DMX values for the DMX
channels using the sliding controls and, if
necessary, the pan and tilt wheels.
3
If necessary, use the button PAGE SELECT
to switch between the two channel groups 1-
10 (red LED lights) and 11-20 (green LED
lights) and repeat steps 1 and 2, until the
desired values are assigned to all channels.
Blackout Function
With the blackout function it is possible to blackout
and illumination scene or chase completely.
Current fadings and chases are not stopped by
the blackout function, they continue "in the dark"
in the meantime.
1
With the button BLACKOUT this function is
switched on: The LED above the button
flashes and all control channels are set to
the output value zero.
2
By pressing the button BLACKOUT again,
the function stops: The LED is extinguished
and all channels return to their pervious
output values.
After Use
After the operation, disconnect the mains plug of
the power supply unit from the socket, to prevent
unnecessary power consumption.
8. ADDITIONAL FUNCTIONS
RDM Functions
Connected RDM devices can be identified and
their DMX address assignment changed.
1
Keep the button AUTO/DEL pressed and
simultaneously press the button PROGRAM.
2
The controller starts searching for RDM
devices. The display indicates e.g.
"DISCOVER COUNT005", when five devices
have been found.
3
Select the desired device with the pan
wheel. The display indicates information
regarding the device in the upper line and
the corresponding DMX address in the lower
line.
4
Use the buttons BANK UP and BANK
DOWN to change the DMX start address as
desired or select from the preset values with
the buttons SCANNER 1-16.
Unit
Button
1
SCANNER 1
2
SCANNER 2
3
SCANNER 3
4
SCANNER 4
5
SCANNER 5
6
SCANNER 6
7
SCANNER 7
8
SCANNER 8
9
SCANNER 9
10
SCANNER 10
11
SCANNER 11
12
SCANNER 12
Table 8.1 Preset values for the start addresses of the
light effect units
5
Confirm your setting with the button
MIDI/REC. To confirm the procedure, all
LEDs of the controller flash three times.
6
Repeat the steps 3 to 5 to adjust further
devices.
37/40
Channel
Start
group
address
A
001
B
011
A
021
B
031
A
041
B
051
A
061
B
071
A
081
B
091
A
101
B
111
A
121
B
131
A
141
B
151
A
161
B
171
A
181
B
191
A
201
B
211
A
221
B
231
00081310.DOCX, Version 1.0
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
