Mobicool MB 40 AC/DC Bedienungsanleitung Seite 10

Operation
➤ Place the cooler on a firm base.
Connecting the cooler to 12 V (thermoelectric mode)
I
NOTE
In thermoelectric mode, the thermostat has no function and the
device cannot deep freeze.
➤ Make sure the cable between the cooler and the battery is protected by a
fuse (maximum 5 A).
➤ Plug the 12 V connection cable (fig. 1 2, page 2) into the cigarette lighter
socket or a 12 V socket in the vehicle.
✓ The cooler starts cooling the interior.
➤ To switch off the cooler:
– Disconnect the plug.
– Wind the cable around the two holders on the back of the device for
storage.
I
NOTE
Disconnect the cooler from the battery when the engine is not run-
ning, as otherwise the battery will run down.
Connecting the cooler to 230 V (compressor mode)
➤ Connect the 230 V connection cable (fig. 1 3, page 2) to the 230 V AC
mains supply.
➤ Open the lid of the thermostat (fig. 2 3, page 2) by pressing down on it.
I
NOTE
Press down on the lid again to close it.
➤ Turn the thermostat (fig. 2 3, page 2) clockwise to the required position.
I
NOTE
The further you turn the thermostat towards "MAX", the lower the
refrigerating temperature.
✓ The cooler starts cooling the interior.
10
MB40
EN