Maintenance; Maintenance Schedule - McCulloch M51-150AWR CLASSIC Bedienungsanweisung

5. Pull with force to start the engine.
WARNING: Do not twist the starter rope
around your hand.
Electrical start (M53-174WRE CLASSIC,
M53-174ARE CLASSIC)
1. Make sure that the battery is charged. See
charge the battery (M53-174WRE CLASSIC,
M53-174ARE CLASSIC) on page 13 .
2. Hold the engine brake handle against the handlebar.
(Fig. 32 )
3. Press and hold the electrical starter button until the
engine starts.(Fig. 33 )
To use the drive on the wheels
• Pull the drive bail in the direction of the handlebar.
(Fig. 34 )
• Before you pull the product rearward, disengage the
drive and push the product forward approximately
10cm.
Introduction
WARNING: Before you do maintenance, you
must read and understand the safety
chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.

Maintenance

Do a general inspection
Examine the oil level
Clean the product
Examine the cutting equipment
Examine the cutting cover*
Examine the engine brake handle*
Examine and adjust the drive (clutch wire)
Examine the muffler*
Examine the spark plug
Change the oil (the first time after 5 h use, then after each 50 h use)
Change the air filter
12
• Release the drive bail to disengage the drive, for
example when you go near an obstacle.
To stop the product
• To stop the drive only, release the drive bail.
• To stop the engine, release the engine brake handle.
To get a good result
To
• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
• Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
• Cut in different directions each time to prevent
stripes in the lawn.
Maintenance

Maintenance schedule

The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * see instructions in
Safety devices on the product on page 9 .
Daily Weekly
X
X
X
X
X
X
X
X
X
417 - 002 - 17.10.2017
Monthly
X
X