Radio Reception; Usb Device Playback - Sony DSX-A212UI Bedienungsanleitung

Radio reception

Stations cannot be received.
The sound is hampered by noises.
 The connection is not correct.
 Check the connection of the car antenna
(aerial).
 If the auto antenna (aerial) will not extend,
check the connection of the power antenna
(aerial) control lead.
Preset tuning is not possible.
 The broadcast signal is too weak.
65 MHz to 74 MHz in FM3 cannot be tuned in.
 [AREA] is set to [EUROPE].
 Set [AREA] to [RUSSIA] (page 11).
RDS
RDS services cannot be received (when [AREA] is
set to [RUSSIA]).
 FM3 is selected.
 Select FM1 or FM2.
 RDS services are unavailable in the current
region.
The SEEK starts after a few seconds of listening.
 The station is non-TP or has weak signal.
 Deactivate TA (page 8).
No traffic announcements.
 Activate TA (page 8).
 The station does not broadcast any traffic
announcements despite being TP.
 Tune in another station.
PTY displays [- - - - - - - -].
 The current station is not an RDS station.
 RDS data has not been received.
 The station does not specify the program type.
Program service name flashes.
 There is no alternative frequency for the current
station.
 Press  (SEEK –/+) while the program
service name is flashing. [PI SEEK] appears and
the unit starts searching for another frequency
with the same PI (program identification) data.

USB device playback

You cannot play items via a USB hub.
 This unit cannot recognize USB devices via a USB
hub.
A USB device takes longer to play.
 The USB device contains files with a complicated
tree structure.
The sound is intermittent.
 The sound may be intermittent at a high-bit-rate.
 DRM (Digital Rights Management) files may not
be playable in some cases.
Audio file cannot be played.
 USB device formatted with file systems other
than FAT16 or FAT32 are unsupported.*
* This unit supports FAT16 and FAT32, but some USB
device may not support all of these FAT. For details,
refer to the operating instruction of each USB device
or contact the manufacturer.
Operations for skipping an album, skipping
items (Jump mode), and searching a track by
name (Quick-BrowZer) cannot be performed.
 These operations cannot be performed when a
USB device in Android mode or iPod is
connected.
 Set [USB MODE] to [MSC/MTP] (page 12).
 Remove the iPod.
 The USB mode of the device is not set to the
appropriate mode.
 Make sure that the USB mode of the device is
set to MSC/MTP mode.
The sound cannot be output during playback in
Android mode.
 While the unit is in Android mode, the sound
outputs only from the Android smartphone.
 Check the status of the audio playback
application on the Android smartphone.
 Playback may not perform properly depending
on the Android smartphone.
17
GB