Radio Reception; Usb Device Playback - Sony DSX-A410BT Bedienungsanleitung

No beep sound.
 An optional power amplifier is connected and
you are not using the built-in amplifier.
The contents of the memory have been erased.
 The power supply lead or battery has been
disconnected or not connected properly.
Stored stations and correct time are erased.
The fuse has blown.
Makes a noise when the position of the ignition
is switched.
 The leads are not matched correctly with the car's
accessory power connector.
During playback or reception, the demonstration
mode starts.
 If no operation is performed for 5 minutes with
[DEMO-ON] set, the demonstration mode starts.
 Set [DEMO-OFF] (page 19).
The display disappears from/does not appear in
the display window.
 The dimmer is set to [DIM-ON] (page 21).
 The display disappears if you press and hold OFF.
 Press OFF on the unit until the display appears.
 The connectors are dirty (page 23).
The display/illumination flashes.
 The power supply is not sufficient.
 Check that the car battery supplies enough
power to the unit. (The power requirement is
12 V DC.)
The operation buttons do not function.
 Press DSPL and
(back)/MODE for more than
2 seconds to reset the unit.
The contents stored in memory are erased.
For your safety, do not reset the unit while you
are driving.

Radio reception

Stations cannot be received.
The sound is hampered by noises.
 The connection is not correct.
 Check the connection of the car antenna
(aerial).
26
GB
 If the auto antenna (aerial) will not extend,
check the connection of the power antenna
(aerial) control lead.
Preset tuning is not possible.
 The broadcast signal is too weak.
65 MHz to 74 MHz in FM3 cannot be tuned in.
 [AREA] is set to [EUROPE].
 Set [AREA] to [RUSSIA] (page 19).
RDS
RDS services cannot be received (when [AREA] is
set to [RUSSIA]).
 FM3 is selected.
 Select FM1 or FM2.
 RDS services are unavailable in the current
region.
The SEEK starts after a few seconds of listening.
 The station is non-TP or has weak signal.
 Deactivate TA (page 11).
No traffic announcements.
 Activate TA (page 11).
 The station does not broadcast any traffic
announcements despite being TP.
 Tune in another station.
PTY displays [- - - - - - - -].
 The current station is not an RDS station.
 RDS data has not been received.
 The station does not specify the program type.
Program service name flashes.
 There is no alternative frequency for the current
station.
 Press  (SEEK –/+) while the program
service name is flashing. [PI SEEK] appears and
the unit starts searching for another frequency
with the same PI (program identification) data.

USB device playback

You cannot play items via a USB hub.
 This unit cannot recognize USB devices via a USB
hub.