Safety Information - Invacare Matrx Libra Gebrauchsanweisung

Invacare® Matrx® Libra®
3. Install the clinical fluid supplement sac(s) inside the
slot/pocket and adjust the clinical fluid supplement sac(s)
to the desired position inside the clinical fluid sac.
4. Refasten the clinical fluid sac hook and loop strips and
re-install the inner liner and outer cover.
Installing Anterior Wedge, Lateral Wedge and/or Tapered
Wedge
Foam wedges can be trimmed to size as needed.
1. Remove the outer cover and inner liner and position the
wedge(s) in the desired position on the underside of
the foam base B as shown:
• Lateral wedge H
• Anterior wedge J and cut to size anterior wedge
• RF/LR tapered wedge K (LF/RR tapered wedge is
not shown)
2. Using the hook and loop strips, secure wedge(s) to the
underside of the foam base.
3. Re-install the inner liner and outer cover.
4.2 Trimming Accessories and/or Foam Base
Components can be trimmed to provide tailored, individual
solutions for the end user. The anterior and lateral wedges
require trimming to fit the foam base. Use a cutter or
scissors to trim these accessories.
CAUTION!
Risk of cutting!
– Take care when using a cutter or scissors.
1.
Trim base of cushion to accommodate leg length
discrepancies, limited joint movement and/or
contractures.
5 Setup
5.1 Installing the cushion
1. Position the cushion so the material identification tags
(not shown) face the rear.
2. Align the hook and loop strips (not shown) on the
bottom of the cushion with those on the wheelchair seat.
If your wheelchair seat has loop strips, use the
enclosed hook adapters to secure the cushion to the
wheelchair seat.
3. Position the cushion onto the wheelchair as far back
as possible.
4. Press down to ensure the hook and loop strips are firmly
engaged.
4
Fig. 4-4
Fig. 4-5
6 Usage

6.1 Safety information

WARNING!
Invacare advise that the patient is assessed by
a trained healthcare professional to ensure the
correct size and seating requirements. This is to
achieve the best pressure and postural care and
that position for the individuals needs are met.
– Always consult a healthcare professional before
using the product.
WARNING!
It is very important for the patient to reposition
themselves, or to be repositioned, on a regular
basis. This relieves pressure which helps prevent
both tissue compression and potential pressure
injury formation.
Skin redness is one clinical indicator for skin
breakdown.
– Regularly inspect/monitor if your skin develops
any redness.
– Immediately contact a healthcare professional,
if your skin develops redness.
IMPORTANT!
Accidental cover damage allows fluid ingress and
staining.
– Do not place sharp objects on the cover.
– When using patient transfer aids, ensure not to
damage the cover. Check for sharp edges or
burrs before use.
– Ensure that the cushion is not jammed or
damaged by sharp edges when used on
wheelchairs.
– Avoid burning cigarettes or open flames near
the cushion.
– If pets are around, ensure that no claws
puncture the cover.
IMPORTANT!
The water resistant cover allows fluids to roll off
the surface, however with sustained periods of
fluid contact the cover may absorb moisture.
– Wipe away any fluid as soon as it is identified.
6.2 Using Cushion
1. Remove all packaging before use.
2. Place cushion on wheelchair or chair with grey anti-slip
base facing down.
3. Ensure that cushion is placed in coordination with
orientation label, located on left hand side of cushion.
Fig. 6-1
1580677-E