Operation
1 2 3 4 5
The luminous flux can be adjusted using the +/- but-
ton. There are five brightness levels available for this
purpose:
Brightness levels
5
10
20
50
100
The remaining running time in hours (h) is automat-
ically displayed for the respectively selected bright-
ness setting!
Maintenance / care
Attention!
Clean the device only when the mains
plug has been removed.
Clean the lamp with hot water, or if necessary
■
with a standard detergent.
Do not use any technical solvents, acetone,
benzene, tetrachloromethane, etc. Likewise, do
not leave in contact with oils or grease for long
periods.
A damaged lead may only be exchanged
■
by the manufacturer or an authorised service
company.
8
100
100
50
80
20
60
10
40
5
20
6
7
8
9
10
Luminous flux
approx. 200 Lumen
approx. 400 Lumen
approx. 800 Lumen
approx. 2,000 Lumen
approx. 4,000 Lumen
Environmental instructions
Do not dispose of this device with
household waste. Dispose of the device
via an approved waste disposal com-
pany or via your local authority waste
disposal facility. Observe the currently
valid regulations. In case of doubt, contact your
waste disposal facility. Dispose of all packaging in
an environmentally compatible manner.
Warranty
We provide a warranty for this Würth device from
the date of purchase and in accordance with the
legal/country-specific regulations (proof of purchase
through invoice or delivery note).
Damage that has occurred will be corrected either
by replacement or by repair. Damage caused by
improper handling is not covered by the warranty.
Claims can only be acknowledged, if the device
is transferred fully non-disassembled to a Würth
agency, your Würth sales representative or a Würth
authorized customer service office.
Subject to technical changes without prior notice.
We accept no liability for printing errors.
Spare parts
If, in spite of careful manufacturing and test proce-
dures, the device becomes faulty, contact Würth
masterService to arrange a repair.
With any enquiries or spare parts orders, always
quote the item number as given on the device type
plate.