INDICATOR LIGHTS
TONER
The LED lights up when there is no toner. To add toner, refer to the section "Adding toner" on page
13.
PAPER
The LED lights up when there is no paper in the selected device (cassette, manual multi-feeder or
optional LCT tray). In this case, the operator must add paper (see the section "Adding paper" on page
10).
PAPER JAM
The LED flashes to indicate a paper jam (see the section "Removing a paper jam" on page 11).
CONTROL CARD (Optional unit)
When the LED flashes, check that the control card is inserted correctly. If the LED continues flashing,
contact the Technical Assistance Service.
"E" INDICATOR (Call the Technical Assistance Service)
The error code "E" followed by a number on the display indicates that the copier is not operating
correctly. Switch the copier off and then on again.
If the problem persists, unplug the machine and call the Technical Assistance Service, notifying them
of the error code.
ADDING PAPER
1. Open the cassette by pressing
on the indicated area.
10
chap1.p65
Downloaded from
www.Manualslib.com
2. Add paper to the cassette. Do
not insert paper beyond the
maximum level.
3. Align the sheets under the
corner tabs.
10
manuals search engine
4. Slowly push the cassette until
it clicks into position.
01/02/00, 10.42