Synchronization Setting [Sync] - Panasonic WV-CL930 Handbuch

6. Synchronization setting [SYNC]

This unit supports the following 5 types of synchronization methods, and one of the following is
selected.
The order of descriptions below indicates the order of priorities.
q Multiplexed vertical drive signal (VD2)
w Power supply synchronization (LL)
* Synchronization is performed on the basis of the power supply frequency.
e Composite color video signal or black burst signal (VBS)
r Monochrome composite video signal or composite synchronizing signal (VS)
t Internal synchronization (INT) (default)
Input of a multiplexed vertical drive signal (VD2) automatically switches to the VD2 synchro-
nization even if the camera is set to other than the VD2 synchronization method.
The set item displays are shown in the chart below with accordance with a synchronization sig-
nal input.
Power supply
frequency [Hz]
50/60
50
60
*1: These items are switchable with use of the right or left button.
*2: When LL, VBS, or VS is selected, power supply synchronizing phase, genlock horizontal
phase, subcarrier phase, and others can be set up. ( pages 32 - 34)
Notes:
• Applicable synchronization methods in areas of 60 Hz of the power supply frequency are
different from in areas of 50 Hz of the power supply frequency.
• The power supply synchronization (LL) setting is changeable only in the 50 Hz areas. The
power supply synchronization (LL) cannot be setup in the 60 Hz areas.
• When "INT" is selected, do not provide synchronization signals to the external synchroniz-
ing input connector on the rear side of the camera.
Downloaded from www.Manualslib.com
Synchronization signal input
VD2
b
b
b
–
–
–
–
–
–
manuals search engine
VBS VS
b
X
X b
X X
b X
X b
X X
b X
b
X
X X
Menu display
VD2
VBS ↔ LL
*1 *2
,
VS ↔ LL
*1 *2
,
INT ↔ LL
*1 *2
,
*2
VBS
*2
VS
INT
31