Maintenance - Concept VP9162 Bedienungsanleitung

DUST RETENTION BAG FILL CHECK
When the dust retention bag fill indicator becomes red during operation, replace the full dust retention bag
immediately.
If the dust retention bag fill indicator is still red after the the bag replacement, it may be due to several causes:
- Some of the air passages (hoses, telescopic tube, suction inlet, brush adapter, or other adapters) are obstructed;
- Motor filter is dirty;
- Air outlet filter is dirty.
Check each of these causes and remove any of them before you start using the appliance. Should you fail to find the
fault, forward the appliance to the service centre nearest to you. Never use the appliance when the dust retention bag
fill indicator is fully red as this may damage the motor beyond repair.

MAINTENANCE

You can clean the accessories and the appliance with a wet cloth. Never immerse the
appliance
in water! Do not use any aggressive substances for cleaning, such as solvents or
abrasives!
DUST RETENTION BAG REPLACEMENT
1. Disconnect the appliance from the mains, pull the hose out of the suction inlet, and
open the appliance's cover (Fig. 3).
2. Remove the full dust retention bag and dispose of it. Make sure it does not get
ripped open when handled.
3. Insert a new bag by sliding the pasteboard lamella into the bag holder, and insert the
holder into the appliance (Fig. 4). The bag opening must be aligned with the hole
in the appliance cover.
4. Only use the appliance when a dust collection bag has been inserted into it! If you
forget to insert the dust collection bag, or you place it incorrectly, you will not be
able to fully close the appliance cover.
5. Close the cover by pushing it until it clicks into the right position.
FILTER REPLACEMENT
• Filters should be cleaned or replaced when they are visibly dirty, or the appliance's
suction power is reduced. Check the filters after every use of the appliance.
• In order not to damage the appliance, do not use it with incorrectly fixed filters.
• Before replacing the filters, disconnect the appliance from the electric voltage
socket.
• You can buy suitable types of filters from your dealer, or you can order them with the
manufacturer.
MOTOR FILTER CLEANING AND REPLACEMENT
1. Disconnect the flexible hose and open the appliance cover.
2. Pull the dust collection bag out of its holder so that you can access the motor filter
more easily.
3. Remove the motor filter (Fig. 5). You can clean the filter by tapping and shaking. If the
filter is heavily soiled, you can wash it in lukewarm water and let it dry properly.
4. Insert the cleaned or new motor filter into the appliance and close the cover.
28
EN
(Fig. 3)
(Fig. 4)
(Fig. 5)
(Fig. 6)
VP9162