Control Elements - Dometic ENERGY & LIGHTING SINEPOWER PerfectCharge MCP1204 Bedienungsanleitung

PerfectCharge MCP1204/1207
• Mode 2: Charge mode with 14.7 V
This mode is used for AGM batteries.
• Mode 3: Voltage supply with 13.7 V (battery is not connected)
This mode is used as a power supply function, e.g. for supplying voltage to the
vehicle in the event of replacing a battery, or during maintenance work using
service devices.
The device can be installed on a wall using the wall bracket for stationary storage
(accessory).
Furthermore, an external battery indicator (accessory) can be used. This shows the
battery capacity and can be connected to the battery permanently using a connec-
tion cable with cable lugs. When it indicates the battery is empty, the battery charger
can be connected to the battery indicator and the battery can be charged directly.
The battery indicator can be attached to a wall or to a wall bracket for the battery
charger using a wall bracket.
6.1

Control elements

I
NOTE
The version for continental Europe is depicted.
No. in
fig. 2,
Designation
page 3
1 Status LEDs
2 Pushbutton
3 230 V cable
4 12 V cable
5 Cable compartment
EN
Description
See chapter "Status indications" on page 14
Selects the operating mode:
Mode 1: Press button for 1 s
(Battery is connected)
Mode 2: Press button for 5 s
(Battery is connected)
Mode 3: Press button for 10 s
(Battery is not connected)
Connection to mains voltage
Connection for the connection cable
For storing the connection cable
Technical description
13