Anti-Theft-Code Function; Rear Zone; System Reset; Mute - ZENEC ZE-NC520 Bedienungsanleitung

ANTI-THEFT-CODE FUNCTION

■ The anti-theft-code setup item exist in the second page of the general setup menu.
Settings
Anti-theft-code 0000
Anti-theft

REAR ZONE

■ If a monitor is installed in the rear zone and connected to the rear zone AV output,
passengers on the back seat can control the DVD output by using the rear zone remote
control.
■ See "Multi-Zone Remote Control" for instructions.

SYSTEM RESET

■ To correct a system halt or other unusual operation, use the tip of a pen to press the
RESET button which is located on the front bottom-left corner of the unit. After a system
reset, the unit restores the settings before the last power off.

MUTE

The volume will be muted when the following cases occur:
■ Automatic: Audio output mutes, when a telephone call is received by the car phone or
when verbal navigation is performed.
■ Manual: Press the MUTE button [
remote control to mute the volume.

NOTE:
■ Press the MUTE button again to restore the volume.
■ Adjusting the volume or using any of the audio setup features will cancel the mute
function.
Downloaded from www.Manualslib.com
Default Options
----
Off On
Off
manuals search engine
Functions
You have to enter the password to turn
anti-theft on or off.
System will require a password, if main
battery power is remove for more than 40
seconds.
No password is required, if main battery
power is remove.
] on the front panel or the MUTE button [
85
ENGLISH
] on the