Cameo ZENIT W300 Bedienungsanleitung Seite 11

Dimmer curves
linear
DMX value
SYSTEM INFORMATION (System Info)
Press MODE to access the selection menu. Using the UP and DOWN controls, select the menu item "System Info" (observe arrow) and
confirm with ENTER.
------------------- Menu ---------
----------
DMX Address
DMX mode
Stand Alone
Slave
Settings
System Info
Use the UP and DOWN controls to select the desired submenu item, and press ENTER to display the corresponding information.
System Info
Firmware = Displays device firmware
Temperature = Displays temperature of LED unit
Operation Hours = Displays operating time
MANUAL LOCKING FUNCTION
In addition to the ability to protect the lamp automatically from accidental and unauthorised operation (see "Settings" - "Auto-lock"), the con-
trols can also be locked manually. Press and hold the UP and DOWN controls simultaneously for approximately 5 seconds. If an attempt is made
to change settings, "Locked!" will appear in the display and changing the lamp's settings via the controls is no longer possible. After approx. 1
minute, the current operating mode is displayed again. To unlock, press and hold the UP and DOWN controls simultaneously for approximately
5 seconds.
The display will show the previously displayed information.
exponential logarithmic
DMX value DMX value
S-curve
DMX value
Main CPU Vx.xx
LED driver Vx.xx
LED xx°C / xx°F
Unit °C (= display in degrees Celsius)
°F (= display in degrees Fahrenheit)
xx:xx h Displays total operating time in hours and minutes
11