Cameo ZENIT W300 Bedienungsanleitung Seite 10

Settings
Wireless Setting =
Display Reverse =
Display Backlight =
DMX Fail =
Dimmer Curve =
Dimmer Response =
Colour Calibration =
Autolock =
LED Frequency =
IR Remote =
Fan =
Factory Reset =
10
W-DMX settings W-DMX On/Off
(Wireless-DMX)
Operating Mode
Transmitting Mode
Link
Receive Reset
Flip display On
Off
Display lighting On
Off
operating status with Hold
DMX signal fault
Blackout
Full On
Stand Alone
dimmer curve Linear
Exponential
Logarithmic
S-Curve
dimmer sensitivity LED
Halogen
Colour calibration Red, Green, Blue, White
Automatic locking of the On
controls
Off
LED PWM frequency 800Hz / 1200Hz /
2000Hz / 3600Hz /
12kHz / 25kHz
activate or deactivate On
control by IR remote
Off
control
Adjusts fan speed Auto
Max Intensity
Low Noise
reset to factory settings Reset Now!
On = W-DMX enabled
Off = W-DMX disabled
Receive = W-DMX module as receiver
Receive = W-DMX module as sender
G3 = G3 broadcasting standard
G4S = G4S broadcasting standard
Link = pair with W-DMX units. W-DMX must be enabled
on all devices, and the pairing with a transmitter be
retained (Receive Reset).
Unlink = decoupling of all devices
No = Do not retain transmitter pairing
Yes = Retain transmitter pairing
= rotate display by 180° (e.g. for overhead installation)
No display rotation
On permanently
Deactivation after approximately 1 minute of inactivity
Last command is retained
Activates blackout
All the LEDs are 100%
Spotlight switches to the last selected stand-alone
mode
Light intensity increases linearly with DMX value
Light intensity can be finely adjusted at lower DMX
values and broadly adjusted at higher DMX values
Light intensity can be broadly adjusted at lower DMX
values and finely adjusted at higher DMX values
Light intensity can be finely adjusted at lower and
higher DMX values and broadly adjusted at medium
DMX values
Lamp responds abruptly to changes in DMX value
Lamp behaves like a halogen spotlight with soft
brightness changes
Individual colour calibration. Cross-mode brightness
setting of the 4 LED groups RGBW with values from
000 - 255
Automatic locking of the controls after approximately
1 minute of inactivity. Display shown upon attempted
use: "Locked!"
To unlock: Press and hold UP and DOWN simultaneous-
ly for approx. 5 seconds
Automatic locking of the controls is disabled
Configuration of LED PWM frequency
IR remote control activated
IR remote control deactivated
Automatic fan speed control
Maximum fan power for maximum brightness
Extra quiet fan with reduced brightness
Reset to factory settings:
Confirm with ENTER. Cancel with MODE