Electrical Safety - Black & Decker dustbuster duo FV7201 Handbuch

the socket. Keep the charger
lead away from heat, oil and
sharp edges.
After use
Unplug the charger before
x
cleaning the charger or the
charging base.
When not in use, the
x
appliance should be stored in
a dry place. Children should
not have access to stored
appliances.
Inspection and repairs
Before use, check the appliance
x
for damaged or defective parts.
Check for breakage of parts,
damage to switches and any
other conditions that may affect
its operation.
Do not use the appliance if any
x
part is damaged or defective.
Have any damaged or
x
defective parts repaired or
replaced by an authorised
repair agent.
Regularly check the charger
x
lead for damage. Replace the
charger if the lead is damaged
or defective.
Never attempt to remove or
x
replace any parts other than
those specified in this manual.
Battery
Never attempt to open the
x
battery for any reason.
Do not expose the battery to
x
water.
Do not incinerate the battery.
x
When disposing of batteries,
x
follow the instructions given
in the section "Protecting the
Environment".
Charger
Do not expose the charger to
x
water.
Do not open the charger.
x
E N G L I S H

ELECTRICAL SAFETY

Your charger has been designed
for a specific mains voltage.
Always check that the mains
voltage corresponds to the
voltage on the rating plate.
Your charger is double
insulated in accordance with
EN 60335; therefore no
earth wire is required.
Never attempt to replace
the charger unit with a
regular mains plug.
INSTALLATION
Fitting the charging base to the
wall (fig. B)
The charging base and the
accessory storage base can be
fitted to the wall to provide a
convenient storage and charging
point for the appliance.
Find a suitable indoor
x
location near a mains outlet.
Place the charging base over
x
the accessory storage base as
shown, so that both sets of
holes line up.
Position the assembled
x
charging / accessory storage
base as shown and mark the
location of the mounting
holes (13) on the wall.
Drill a hole (ø 6 mm, approx.
x
35 mm deep) at each of the
marked locations.
Insert the wall plugs provided
x
into the holes.
Fit the assembled charging /
x
accessory storage base to the
wall using the screws
provided. Guide the charger
lead through any of the 3
slots (14).
Excess lead can be stored at
the rear of the charging base.
7