Installation; Inserting / Replacing Batteries; Battery Type - HASE Luno Gas Bedienungsanleitung

2.

Installation

2.1 General Fitting Information
Inlet pipe connection
Chimney requirements
Flue monitor
NOx - Level
Approved fl ue gas system
Before installation of these appliances, the area into which the fi re is to be fi tted must be
cleared of all debris (including dust), in particular combustible material.
Failure to comply with the instructions in this manual, or the regulations and standards could
have hazardous consequences.
2.2 Stove Location
These appliances are designed with the
"Firebox" raised up off the ground level
by the built in "Base unit".
Thus these appliances require no spe-
cial Hearth arrangements, as the fl oor
will not get hot and is protected by the
steel construction of the "Base unit".
If the appliance has to be located in an
opening, a minimum clearance of 5 cm
should be allowed to non-combustible
materials.
The stove must be located at least 30
cm from any combustible materials.
Downloaded from www.Manualslib.com
8 mm, 12mm compression
Balanced Flue
Permanent Pilot
see technical specifi cations at beginning of manual
Metaloterm Ontop Serie US Ø 100/150
Fig. 2
manuals search engine
2.3

Inserting / Replacing Batteries

An audible signal (three short beeps) indicates that the batteries need to be replaced.
To insert or replace the batteries of the receiver, remove the lock screw and pull out the
receiver (see Figure 3, 4). Open the battery compartment cover and insert the batteries, then
push the receiver back in and secure it with the lock screw.

Battery type

Receiver: 4x AA, R6 size. Alkaline only
Transmitter: PP3 (Alkaline only).
Fig. 3 Fig. 4
63