Setting Up And Aligning The Appliance; Cleaning Before Use; Connecting The Appliance - hanseatic SC-130RG Gebrauchsanleitung

Setting up and aligning the
appliance
1. Place the appliance on as flat and as firm
a base as possible.
2. To ensure sufficient air circulation, do not
place the appliance directly against the
wall. Leave a gap of at least 10 cm to the
back wall and 5 cm to the sides and the
top.
3. Check the position with a spirit level.
4. Level out any unevenness on the ground
using the two front screw feet (3).
– Close the glass door (2).
– Tilt the appliance backwards slightly and
screw/unscrew the screw feet.
– Stand the appliance back up again and
check the alignment with a spirit level.
Repeat the process until the appliance
is standing up vertically. The appliance
should not move when opening the glass
door.
Start-up

Cleaning before use

To remove the odour that comes with all new
appliances, clean the appliance before using it
(see 'Care and maintenance' on page EN-13).

Connecting the appliance

WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or death.
Do not operate or continue to oper-
■
ate the appliance if
it shows visible signs of damage,
–
e.g. the power cord is defective,
it starts smoking or there is a smell
–
of burning,
it makes unfamiliar noises.
–
In such cases, remove the mains plug
from the socket and contact our ser-
vice department (see page EN-21).
Only connect the appliance to a prop-
■
erly installed and earthed electric
socket.
Connection to a timer or separate re-
■
mote control system for remote mon-
itoring and controlling it is not per-
mitted.
Do not kink or pinch the mains cord
■
or lay it over sharp edges.
All other important operating infor-
mation can be found starting on
page EN-10.
Page EN-17