Mounting - Pelgrim GVW820 Anleitung

Mounting

Installing door panel (see fig. 15)
First determine the height of the control
panel.
Place the template on the inside of the door
panel.
The measuring marks correspond to the
measured height of the panel.
Centre the template on the right and left
sides with the aid of the measuring marks.
Transfer the markings of the drill holes on
the template onto the door.
If the door panel is made of solid wood,
predrill the holes with a 2 mm drill (12 mm
deep).
Note:
Allow for possible differences in the thickness
of the panel (milled hollows or bevelled
edges).
Fix the mounting material to the door, as
indicated on the template.
fig. 15
Attach the panel to the door of the
dishwasher by pressing the upper pins into
the slots of the plastic section.
Slide the panel up a little, and attach the
underside as indicated in fig. 16.
Adjusting the spring tension (see fig. 17)
As standard setting, the door is adjusted to
the lowest spring tension.
Increase the tension of the spring by
turning the two adjusting screws in a
clockwise direction with a screwdriver.
The tension of the spring is correct if the
door is in a state of equilibrium when open.
fig. 16
fig. 17