Mounting - Pelgrim GVW835E Anleitung

Mounting

Installing door panel (see fig. 14)
Place the template on the inside of the door
panel. The top of the template is the top of
the door panel.
Transfer the markings of the drill holes on
the template onto the door.
If the door panel is made of solid wood,
predrill the holes with a 2 mm drill (12 mm
deep).
Note:
Allow for possible differences in the thickness
of the panel (milled hollows or bevelled
edges).
Fix the mounting material to the door, as
indicated on the template.
fig. 14
Attach the panel to the door of the
dishwasher by pressing the upper pins
(fig. 15a) into the slots of the plastic section.
Slide the panel up a little. Screw the panel
tight from the inside, as shown in figure 15b.
fig. 15a
fig. 15b