Cleaning And Maintenance - SATA 95208 Bedienungsanleitung

Notes:
1 ）Remove the bolts （two points in total） fixing the bottom plate and * plate after opening the package, wear gloves during the removal and do not touch the metal frame
around the * plate to prevent scratches.
2）Tear off the membrane of the workbench before using.
3）The four circular holes on the workbench are used for installation of bench vice, and the SATA heavy duty square steel bench vice 4''（model 70841） is recommended.
4）The key of workbench（two types, four in total） is put on the spring bolt of door lock.
5）The plastic box beside the workbench is detachable.
Precautions:
No.
1
2
3
4 During the operation process, do not open more than three（including 3） drawers at the same time, to prevent the tipping of the tool car caused by
5 Do not put the articles beyond reasonable load of the drawer. Prevent drawer deformation and ensure smoothly drawing
6 Before locking the tool car, make sure the drawers are completely closed. Do not slam the drawer after closing, resulting in damage of the plating pieces
7 Before locking the tool car, make sure the drawers are completely closed, do not slam the drawers which are not completely closed after locked, so as
8 Before moving tool car, loosen the break device of two universal casters. Do not forcibly move the tool car without loosening the break. which may cause
9 When the tool car is moved to the designated place for on-site maintenance, the casters of the tool car must be locked and the car shall be operated
10 Do not disassemble parts and components such as drawers, lock devices, workbench of the tool car if it is not necessary

Cleaning and Maintenance:

To improve the service efficiency, please regular lubricate the sliding rails of the tool car with light grease（the sliding rails of drawers are equipped with a black snap spring.
When remove a drawer, press down the reed on the left sliding rail and up the reed on the right sliding rail at the same time, then apply a force to pull out the drawer, after
the sliding rail lubrication, inset the drawer to sliding rail and push it to the bottom）, it is suggested to lubricate at least twice a year, or increase the times as appreciate.
12
95208/95208S
When moving the tool cart, please close all drawers to prevent the tool car from toppling over
Push the tool car instead of pulling. In order to control the direction of movement
When moving the tool car, do not put too much tools or other articles on the car to prevent unexpected circumstances
中文
Contents
opening drawers full of articles
and plating tanks
not to damage the plating device
damage to components of tool car
under the moving state
EN DE RU KO PT JA ES