Roborock S6 MaxV Handbuch Seite 20

Installation
3. Attach the Moisture-Proof Mat
After fixing the Charging Dock in place, use a dry cloth to clean the area
where the Moisture-Proof Mat will be located. Peel off the outer layer
of the double-sided tape attached to the bottom of the Moisture-Proof
Mat, and stick the mat to the ground as shown.
Note:
・
Always place the Moisture-Proof Mat on wooden floors.
・
Peel the double-sided tape slowly to minimize residual adhesive.
・
The Moisture-Proof mat attaches better to smooth surfaces.
4. Powering On and Charging
Press and hold the
power light is steady, and then place the robot on the Charging Dock to
charge. The robot is equipped with a built-in high performance lithium-
ion rechargeable battery pack. To maintain battery performance, keep
the robot charged during normal use.
Note:
The robot may not be turned on when the battery is low. In this case, connect the robot to the
Charging Dock.
19
button to power on the robot. Wait until the
The color of the power
indicator indicates the
battery level.
・
White: ≥ 20%;
・
Red: < 20%