Power Supply - AEG CTV 4894 Bedienungsanleitung

English
50
A. With the alternating
current adapter
B. With the adapter for
the cigarette lighter
05-CTV 4894_GB.indd 50 05-CTV 48 _GB.indd 50
1. Open and remove the battery compartment cover.
2. Insert two batteries of type AAA/R03 (1.5 V), ensure correct polarity
(+ and -). Start with the negative pole (-).
3. Attach and close the battery compartment cover.
NOTE:
The signals from the remote control are transmitted to the DVD-Player
by infrared light. You should therefore take care that the DVD-Player is
not exposed to the direct sunlight. This could make the transmission of
signals from the remote control to the DVD-Player impossible.
Eff ective range of the remote control
If you want to use the remote control it has to be pointed at the remote
control sensor on the front of the device. The distance between remote
control and sensor should not exceed 5 m. The angle of the remote
control to the remote control sensor to right, left, top and bottom should
not exceed 30°.

Power Supply

The alternating current adapter works with alternating current of
between 100 V and 240 V, but
In Europe the mains lead (supplied) may only be connected to an
alternating current power source of 230-240 V.
When connecting to an alternating current source outside Europe a
plug adapter must be used that conforms to the socket.
1. Insert the cable from the alternating current adapter into the DC IN
9V socket (Fig. 2/18) of the device.
2. Connect the alternating current adapter to a correctly installed shock-
proof socket.
ATTENTION:
The alternating current adapter supplied is intended for use only
with this device. Do not use it with other equipment.
If the device is not going to be used for a prolonged period the
alternating current adapter must be removed from the power socket.
The cigarette lighter adapter is used in vehicles that have a 12 V power
supply with negative earth.
Connect the plug from the cigarette lighter to the DC IN 9V socket
(Fig. 2/18). Then insert the cigarette lighter into the corresponding
socket in your vehicle.
Precautionary Measures:
This device may only be used with the original vehicle adapter, as a
diff erent adapter can damage the device.
The original vehicle adapter may only be used for this device. Do not
use it for other equipment.
Do not use the device when driving. Ensure that the device is fi rmly
fi xed in place or stowed away and cannot fall into the vehicle in the
case of an accident.
20.03.2008 12:01:09 Uhr 20.03.2008 12:01:09 Uhr