Routing Electric Cables; Connecting The Ventilation Pipe - Kessel LW1000 Einbau- Und Betriebsanleitung

Shortening the upper section (optional)
Mark the upper section (1) all the way round in such a
way that it projects at least 10 cm into the waterproof
extension section (2).
Use a jigsaw (15°) to saw the excess off.
Deburr the edges.
Gluing tiles to the cover plate
Apply tile adhesive (on MS polymer basis) to the tiles, select quantity and thickness of the adhesive depending on the tile
thickness. However, do not seal the tile all the way round, so that the adhesive can dry. Do not grout the tiles until 24 hours
have passed (flexible grout) and follow the manufacturer's processing instructions.
NOTICE
Risk of crushing and hazard due to heavy weight.
The cover plates of the upper sections are extremely heavy. Only install/dismantle using suitable lifting gear.
Always fit the upper section onto the chamber without the cover plate.
4.5

Routing electric cables

Fix cable fasteners (1) (optional) to the scoring points (2).
Use the fixing screws to fix these in place.
Make sure that the fixing screws are not longer than
16 mm.
The chamber wall could leak.
An appropriate hole saw can be used for a cable passage.
Height of interme-
diate section [cm]
250
500
Taper
Seal for pipe penetration
DN50 (Ø 50)
DN70 (Ø 75)
DN100 (Ø 110)
DN125 (Ø 125)
DN150 (Ø 160)
4.6

Connecting the ventilation pipe

When routing the ventilation pipe, make sure you leave sufficient room for later fitting and maintenance work.
All the system components (pumps, backwater flaps and pipework) must remain easily accessible.
Route the ventilation pipe above the backwater level using a seal for pipe penetration.
010-701
Maximum diameter
DN100
DN150
DN200
Art. no.
850114
850116
850117
850118
850119
Engineering chamber LW 1000 /
Installation and operating instructions
31 / 100