Herunterladen Inhalt Inhalt Diese Seite drucken

LANCOM 800 Installationsanleitung Seite 26

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 6
Downloaded from
www.Manualslib.com
LANCOM Routers, WLAN Routers, Access Points and WLAN Controllers
How to reset the device?
If you have to configure the device regardless of possible existing settings, or
if a connection to the device configuration failed, you can put back the device
into the factory default state with a Reset.
ETH4
ETH3
ETH2
ETH1
Config(COM)
Reset
The reset button offers two basic functions—boot (restart) and reset (to the
factory settings)—which are called by pressing the button for different
lengths of time.
With the suitable setting, the behavior of the reset button can be controlled
accordingly.
Configuration tool
WEBconfig, Telnet
Reset button
This option controls the behavior of the reset button when it is pressed:
Ignore: The button is ignored.
Please observe the following notice:
only' makes it impossible to reset the configuration to the factory set-
tings using the reset button.
If the password is lost for a device with this setting, there is no way to
access the configuration! In this case the serial communications inter-
face can be used to upload a new firmware version to the device-this
resets the device to its factory settings, which results in the deletion
of the former configuration. Instructions on firmware uploads via the
serial configuration interface are available in the LCOS reference
manual.
Boot only: A press of the button prompts a restart, regardless of how
long the it is held down.
manuals search engine
Reset switch (according to the model type
WAN
ISDN
COM
Antenna Main
Call
Expert configuration > Setup > Config
First steps
on the front or rear panel)
LANCOM 8011 VPN
The settings 'Ignore' or 'Boot
10

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis