Filling The Tank; Mowing Tips - Ryobi RLM1956MEB Übersetzung Der Originalanleitung

Use fresh fuel.
Store fuel in containers specifically designed for this
purpose.
Always refuel outdoors where there are no sparks and
flames. Do not inhale fuel vapour. Do not smoke and
tank or when handling fuel.
Do not let petrol or oil come in contact with your skin.
Keep petrol and oil away from the eyes. If petrol or oil
comes in contact with the eyes, wash them immediately
with clean water. If irritation is still present, see a doctor
immediately.
Clean up spilled petrol immediately.

FILLING THE TANK

Always shut off engine and allow it to cool for 5 minutes
before refuelling. Never remove the cap of the fuel tank
or add petrol to a machine with a running or hot engine.
Move at least 9 m (30 ft) from refuelling site before
starting the engine. Do not smoke. Failure to heed this
warning could result in serious personal injury.
of the fuel neck. After fueling, never tilt the mower more
1. Clean surface around fuel cap to prevent contamination.
Loosen fuel cap slowly to release pressure and to keep
fuel from escaping around the cap. Rest the cap on a
clean surface.
3. Carefully pour petrol into the tank. Avoid spillage.
4. Clean and inspect the gasket, then replace all fuel and
container caps securely.
5. Wipe up any fuel spillage. Move 9 m away from
refuelling site before starting engine.
NOTE: It is normal for smoke to be emitted from a new
ADDING/CHECKING ENGINE OIL
and service life. For general, all-temperature use, SAE
10W-30 is recommended. Always use a 4-cycle motor oil
that meets or exceeds the requirements for API service
NOTE:
the engine and should not be used.
Downloaded from www.Manualslib.com
WARNING
WARNING
manuals search engine
To add engine oil:
1.
is clean.
Remove the cap and seal from oil bottle.
3.
4. Slowly add oil. Fill to the "Full" line on dipstick. Do not
NOTE: When checking the oil level, seat the dipstick in the
5.
To check engine oil:
is clean.
Add oil as needed.
STARTING OR STOPPING THE MOWER
WARNING
Never start or run the engine inside a closed or poorly
ventilated area; breathing exhaust fumes can kill.
NOTE: Reduce the throttle setting during engine shut
down. If the engine is provided with a shut-off valve, turn
the fuel off at the conclusion of mowing.
Starting the engine
1. Press the primer bulb 3 times.
NOTE: This step is not usually necessary when starting
an engine that has already run for a few minutes.
Hold the power lever bar down against the handle.
3. Pull the starter grip until the engine starts. Release the
starter cord slowly so the rope does not snap back.
NOTE: It may be necessary to repeat priming steps in
cooler weather. In warmer weather, overpriming may
cause flooding and engine will not start. If you do flood
the engine, wait a few minutes before attempting to
start and do not repeat priming steps.
Stopping the engine
Release the power lever and allow the engine to come
to a complete stop.

MOWING TIPS

Make sure the lawn mower mowing area is clear of
stones, sticks, wires, and other objects that could
damage the lawn mower blades or engine. Such
objects could be accidentally thrown by the mower in
any direction and cause serious personal injury to the
operator and others.
For best performance, always cut off one-third or less of
the total height of the grass.
EN
English
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG