Building; Building From The Sd Card - Dremel 3D20 Original Bedienungsanleitung

TIP: Standard printer paper can also be used to
level the build platform in the same manner as the
levelling tool.
5. Tap "Next" to move the build platform toward the
right knob and repeat step 4 above.
6. Tap "Next" to move the build platform toward the
rear knob and repeat step 4 above.
7. Tap "Finish" to complete the levelling process.
8. Repeat steps 1 through 6 above to ensure that
build platform is completely level.

BUILDING

OBSERVE ALL PROVIDED
WARNING
!
WARNINGS AND SAFETY
INSTRUCTIONS WHEN USING THE DREMEL 3D20.
FAILURE TO DO SO MAY RESULT IN FIRE,
EQUIPMENT DAMAGE, PROPERTY DAMAGE OR
PERSONAL INJURY.
NOTE: Your Dremel 3D20 will build test objects before
leaving the factory. These test objects may have
been made with a different filament colour than you
are using. Therefore, a small amount of filament may
be remaining in the extruder. The start of your first
object may have some of this filament colour until it
transitions over to your filament colour.
You have 2 options when building on your Dremel
3D20:
1. SD Card - Build directly from the SD card. The
SD card comes with model files installed at the
factory. You can plug this directly into your builder
and begin building right away. Additionally, you can
save new .G3Drem files to your SD card from the
Dremel 3D software.
2. Computer – Build directly from your computer
through the USB cable.
FILE EDIT BUILD VIEW TOOLS HELP
LOAD
3D ONLINE
BUILD
VIEW
MOVE
ROTATE
SCALE
IDEA BUILDER
STATUS : PRINTING

BUILDING FROM THE SD CARD

1. Insert SD card containing your model into the
SD port located on the right side of your Dremel
3D20. Your Dremel 3D20 comes with an SD
card containing free model files ready to be built.
Additionally, you can save new .G3Drem files to
your SD card from the accompanying Dremel 3D
software.
2. Ensure an adequate amount of filament is loaded
(see page 19).
NOTE: You cannot edit model files directly on
the Dremel 3D20. Ensure that you are building
.G3Drem files when building directly from SD card.
3. Ensure build tape is applied and build platform is
levelled (see page 20).
4. Tap "Build" on the touch screen, tap the SD card
option, and use the up/down arrows to scroll.
5. Tap on the model file you would like to build.
6. Your Dremel 3D20 will first align the extruder and
build platform. Your Dremel 3D20 will then begin
the heating process which may take a few minutes.
During the heating process, the extruder will reach
the temperature required for proper building with
PLA. Once this temperature is reached, your model
will begin to build.
7. Once the object is finished building, your touch
screen will display "Object Finished". Tap the check
box to confirm.
8. Wait until the touch screen indicates that the
extruder temperature is "COOL" to remove you
object . See section for removing you object
from the build platform below for object removal
instructions.
CANCELLING YOUR OBJECT ON DREMEL 3D20
To cancel your object during warm up or building, tap
the "STOP" button on touch screen. The next screen
will read, "Cancel build now?" Tap the "Yes" to cancel
or tap "No" box to abort the cancel command. Wait
until the extruder and build platform completely cools
before reaching inside the build area.
21