Silvercrest SSJBE 300 A1 Bedienungsanleitung Seite 50

NOTE
► Normally, the appliance draws in the prepared ingredients automatically
once they have been placed in the feed tube
pusher
appliance, otherwise the appliance may block.
5) Add more ingredients to the feed tube
press the ingredients carefully into the feed tube
are being processed, add further pieces into the feed tube. Do not switch off
the appliance while processing.
NOTE
► If you want to add ingredients that are too large for the feed tube
stop the appliance by moving the On/Off switch
Flip open the lid of the feed tube
Then close the lid again and continue processing.
NOTE
► If pieces of food get stuck during operation, switch off the appliance and
move the On/Off switch
succession to reverse the motor. If this does not help, either, dismantle the
appliance as described in the section "Dismantling" and remove the stuck
pieces of food.
► If food is stuck in the feed tube
, proceed as follows:
–
Switch off the appliance and pull the plug of the power cable
of the socket.
–
Turn the housing lid
towards the
–
Remove the housing lid
–
Remove the food pieces causing the blockage.
–
Reassemble the appliance and resume operation.
│ GB │ IE
■ 46
if you notice that the ingredients are not being drawn into the
into the "R" position several times in quick
anticlockwise until the
marking on the sieve tray holder
.
. Push gently with the
. If required, use the pusher
. While the ingredients
to the "O" position.
and add the ingredients directly.
and cannot be freed with the pusher
marking points
.
to
,
out
SSJBE 300 A1