Electrolux EN3854POX Benutzerinformation Seite 12

12 www.electrolux.com
Problem
Water flows inside the re‐
frigerator.
Water flows on the floor.
Temperature cannot be
set.
The temperature in the
appliance is too low/too
high.
Side panels of the appli‐
ance are warm.
There is too much con‐
densed water on the rear
wall of the refrigerator.
Door does not open easi‐
ly.
Possible cause
The water outlet is clog‐
ged.
Food products prevent
water from flowing into
the water collector.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The FastFreeze or Shop‐
pingMode function is
switched on.
The temperature regulator
is not set correctly.
The food products tem‐
perature is too high.
Many food products were
stored at the same time.
The FastFreeze function
is switched on.
This is a normal state
caused by operation of
the heat exchanger.
Door was opened too fre‐
quently.
Door was not closed com‐
pletely.
Stored food was not
wrapped.
You attempted to re-open
the door immediately after
closing.
Solution
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.
Attach the melting water out‐
let to the evaporative tray.
Switch off FastFreeze or
ShoppingMode manually, or
wait until the function resets
automatically to set the tem‐
perature. Refer to "Fast‐
Freeze or ShoppingMode
function".
Set a higher/lower tempera‐
ture.
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Refer to "FastFreeze func‐
tion".
Make sure that there is at
least 30 mm of space be‐
tween each side of the appli‐
ance and the surrounding
furniture when the ambient
temperature exceeds 38°C.
Open the door only when
necessary.
Make sure the door is closed
completely.
Wrap food in suitable pack‐
aging before storing it in the
appliance.
Wait a few seconds between
closing and re-opening of the
door.