Canon FAX-L280 Bedienungsanleitung Seite 3

For your safety (Australia only)
To ensure safe operation the three-pin plug supplied must be inserted only into
a standard three-pin power point which is effectively earthed through the
normal household wiring.
Extension cords used with the equipment must be three-core and be correctly
wired to provide connection to earth. Wrongly wired extension cords are a
major cause of fatalities.
The power point shall be located near the equipment and shall be easily
accessible.
The fact that the equipment operates satisfactorily does not imply that the
power point is earthed and the installation is completely safe. For your safety,
if in any doubt about the effective earthing of the power point, consult a
qualified electrician.
Caution (New Zealand only)
1. This equipment may not necessarily provide for the effective hand-over of
a call to or from a telephone connected to the same line.
2. The operation of this equipment on the same line as telephone or other
equipment with audible warning devices or automatic ring detectors will
give rise to bell tinkle or noise and may cause false tripping of the ring
detector. Should such problems occur, the user is not to contact Telecom
faults service.
3. Should this equipment become physically damaged, disconnect immediately
from the Telecom connection and power source and contact your nearest
service agent.
4. To relocate this equipment please.
1)
2)
3)
4)
5. If the supply cord of this equipment is damaged, it must be replaced by the
special cord (Parts No.: HH2-1910).
6. Not all standard telephones will respond to incoming ringing when
connected to the extension socket.
7. This device may be subject to bell tinkle, or mistakenly enter receive mode
when calls are made from another device on the same line. If this occurs,
the problem should not be referred to the Telecom Faults service.
8. Please note when you connect an extension phone to this device, if you use
an extension phone which has features such as "last number redial", redial
memory numbers may be lost.
Vorwort
Disconnect the equipment from the Telecom connection.
Disconnect the equipment from the power source.
Reconnect the equipment to the power source.
Reconnect the equipment to the Telecom connection.
iii