Bluetooth Remote Control - Lupine SL ax StVZO Handbuch

Bluetooth remote control

The Bluetooth Remote comes together with the Peppi V5 barmount. On the bike, the best way to mount
the remote is directly next to your grips so you have full control and don't need to take off your hands while
riding.
Connecting the transmitter to the light:
By default, your lamp has already been connected to the transmitter.
For establishing a connection, the receiving mode of the lamp has to be activated.
After connecting the lamphead to the battery, the lamphead is in receiving mode for 15 seconds.
During this time, press the remote control's big button for about 5 seconds, until the remote confirms by
lighting up blue. Release the button immediately.
24
SL AX StVZO
Low button cell:
With decreasing voltage, the remote control LEDs will shine less bright. Also cold temperature does reduce
the battery voltage. If the button cell is near empty, it's shown by a red light.
Transmitter battery change:
Peppi V5 also available for
To change the transmitter button cell a T5 torx screw driver is needed.
32mm, Art. No.: 1086
Insert the new CR 2032 button cell as shown and close
the transmitter again.
Tighten the screws until the blue sealing is visibly squeezed.
T5 torx screw driver: (Art.No. 137)
Bluetooth remote control
25
SL AX StVZO