Ir Remote Control (Optional) - Cameo ROOT PAR TW Bedienungsanleitung

IR REMOTE CONTROL (optional)

Aim the infrared remote control directly, within line-of-sight, at the infrared sensor
installed on the front side of the spotlight. The maximum range is approx. 26.24
feet. The spotlight's sensor is deactivated in DMX and slave mode.
The infrared remote directly controls the internal stand-alone modes: Direct, CCT,
and Loop/Sound.
BL / ON/OFF (Blackout)
The BL (Blackout) button switches off all LEDs, regardless of which operating
mode is activated via the remote control. Press the BL button again to reactivate
the previously selected mode.
SP (Speed)
11-step speed setting for the lighting sequence in the stand-alone mode Loop (Au).
Step 1 allows the lighting sequence to progress quickly, pressing it again activates
step 2 with a slower color change sequence, and this is followed by steps 3, 4, 5,
etc., where step 11 is the slowest lighting sequence.
☼ ☼ (Brightness)
Set the overall brightness in six steps. Press this button several times (Step 1 =
blackout) to access the different brightness levels.
FL (Flash/Strobe)
Speed setting for the strobe effect in six steps. Step 1 deactivates the strobe effect, step 2 produces a slow frequency followed
by steps 3 to 5. Step 6 produces the fastest flash frequency. The strobe effect can only be used in the CW/WW color mixing mode.
CW and WW (R, G, B, W, A, and UV have no function)
These two buttons allow individual color temperatures to be created by mixing cold white and warm white. The six brightness levels can be
accessed by pressing the respective color button again, where level 1 means that the LEDs are switched off.
Ju (no function)
Fa (no function)
Au (Loop mode)
Press the Au button to start the stand-alone mode Loop. Use the Speed button to control the speed of the lighting sequence.
Su (music-triggered lighting sequence)
For bass, the preconfigured color temperature presets in the stand-alone mode Loop under Step 1 and Step 2 change.
The control microphone is located on the back of the spotlight; the microphone sensitivity is preset in the stand-alone loop mode.
CM (CCT)
Press CM+ or CM- to start the CCT stand-alone mode. The CM+ and CM- buttons are used to set the color temperature in 100 K steps from
3100 K to 6500 K in this mode.
Pr+ / Pr- (no function)
13