Panasonic AW-E750E Bedienungsanleitung Seite 22

(Wall)
Mounting screw for wire (supplied)
(Inch screw: 1/4-20UNC)
Spring washer (supplied)
Flat washer (supplied)
AW-E750/AW-E655
Notes
p When installing the mounting bracket or attaching one
end of the drop-prevention wire to the ceiling or a wall, be
absolutely sure to use the anchor bolts, and ensure that
the withdrawal strength of the installation surface is at least
ten times the total mass of all units installed, including the
mounting bracket, camera, lens, and cables.
p Ensure that the total mass, including the mounting bracket,
camera, lens and cables, does not exceed 8 kg.
p Ensure that a drop-prevention wire is installed in such a
way that the drop distance does not exceed 150 mm.
Secure the end of the wire onto the M6 anchor bolts by
tightening nut or secure it by tightening the M6 bolts.
Drop-prevention wire (sold separately)
Mounting screw for wire (M4)
(supplied)
Always mount using
the anchor bolt.
Camera mounting bracket [*]
Flat washers [*]
Spring washers [*]
Mounting screws [*]
(Inch screws: 1/4-20UNC)
[*]: Procured locally
- 21 (E) -
AW-E650/AW-E350
( The mounting method shown in the illustration
above is for the AW-E650 and AW-E350.
The same method is used for both models.)
p Tighten the mounting screws using the torque levels
shown in the table to the below, and then check for play
and unsteadiness.
Screws
Mounting screws (M4)
Mounting screws (Inch screws)
p Do not use an impact driver as doing so may cause
damage to the screws.
Always mount
using the
anchor bolt.
Clamping torque
1.5 N • m (15 kgf • cm)
2.0 N • m (20 kgf • cm)