Troubleshooting - Seg TO 102B Bedienungsanleitung

7 TROUBLESHOOTING

DANGER!
• Never connect the device to the power supply if the device,
the power cord or the mains plug are visibly damaged.
• In case of danger or in case of a defect, pull the mains plug
immediately out of the socket.
• Never try to repair the device yourself.
If your device does not work properly, contact the retailer from
where you purchased the device.
• If the power supply cord is damaged it may only be replaced
by the manu -
f acturer or by a manufacturer-authorized after-sales service or
by a qualifi ed specialist (electrical engineer) to avoid hazards.
• Never operate a defective device.
• Never operate a device that has fallen down.
If failures occur during operation, please check the following table to see if you can solve the
problem yourself. All other repairs are prohibited and the warranty is void.
Problem
Device will not switch on.
Bread has not the desired
browning level.
Device turns off automatically. The cancel button (5) has been
The bread lift (3) cannot be
pressed down.
08/2020
Cause
Device is not connected to the
power supply.
The bread lift (3) has not been
pressed down.
Control knob to set the
browning level (4) has been
selected too low.
pressed by mistake.
The device is not connected
with the power supply.
Action
Plug the mains plug into a
socket outlet with earthed
contact.
Press down the bread lift (3).
Adapt the browning level to
the sort of bread (light or dark,
fresh or old) and repeat the
toasting process.
Press down the bread lift (3)
again.
Connect the toaster with the
power supply.
41