Hoover Pure Power PU31PU10 Bedienungsanleitung Seite 7

CHanging BELT Or BrUSHES
imPOrTanT: Switch cleaner off and
2
1
remove plug from electricity supply
before checking the brushes or remov-
ing hood.
If your cleaner is not picking up efficiently, the belt or
brushes (or both) may need replacing, but first make
sure you have:
• Emptied the dust container
• Cleaned filters
• Checked for blockages
1
remove hood
• Prise off the carpet care control selector.
• Remove hood screws A and B.
• Lift off hood.
2
remove brush assembly
• Inspect belt for signs of wear.
• To remove, pull brush cleaner assembly upwards
out of cleaner housing. Remove belt from motor
spindle then from brush assembly.
replace belt
• Loop the new belt around the motor spindle then
around the brush channel.
* Certain models only
3
4
A
B
5
removing a blockage from the
Pet Hair & allergen remover*
Open clip and lift cover to remove
blockage.
CLEaring a BLOCKagE
Refit brush assembly
• Hold the brush assembly
and stretch the belt until
brush mountings slot
down into the cleaner
housing. Rotate the
brush to ensure free
movement of the belt.
Refit hood
• Refit hood, ensuring the
lugs along the front of
hood are located in the
slots along the front edge
of baseplate.
• Secure hood, using
screws A and B.
Refit carpet care control
selector
• Ensure the raised face
(T) is towards the front of
the cleaner.
- 7 -
!
imPOrTanT: Switch the cleaner off
and remove the plug from the elec-
tricity supply before dismantling
cleaner.
This cleaner is unlikely to become blocked, except
by over filling of the dust bag or accidentally picking
up large solid objects. Clearing a blockage is simple.
If cleaning tools were in
use, check cleaning tool
and extension tube first.
Next check hose handgrip;
to remove grip ribbed ring
as shown, turn in direction
of arrow and ease apart.
To check the hose, stretch it
to full length and switch on
the cleaner; the suction will
dislodge most obstructions.
If this is
switch off and unplug the
cleaner. Remove the hose
by turning it anti-clockwise
as shown. Detach hose and
remove blockage.
For blockages in cleaner base:
1. Turn the cleaner over
and check that the brushes
are free to rotate.
2. Check for a blockage in
hose socket. Use a piece of
wire or a blunt flexible rod
to remove any obstructions.
gB
unsuccessful,